Waggle Device + App Setup Guide

PART 1: Hardware Setup

1) Make sure your WiFi router is connected to the internet.

1.png

2) Power on your 3D printer.

Setup-Guide1.jpgnext300.png2.png

* Waggle is not connected to the printer at this point.

3) Connect the power offed Waggle and your printer with the cable.

Setup-Guide3-1.pngSetup-Guide4-1.png

next300.png3.png

4) Power on your Waggle device. Make sure the power LED on the side is turned on.

Setup-Guide5-1.pngnext300.png4.png

5) If the Green LED on the left side stops blinking, tap "Next".

Setup-Guide-Green-LED.gifnext300.pngSetup-Guide7.jpg

next300.png5.png

6) In order to make Waggle AP mode,press and hold the "Config" button on your Waggle.Release your finger if the side Green LED starts blinking.

Setup-Guide6.jpgnext300.png6.png

7) Wait until the side Green LED stays. Make sure the front LED is blinking in blue.

Setup-Guide-Green-LED.gifnext300.pngSetup-Guide7.jpg

next300.pngSetup-Guide-Blue-LED.gifnext300.png7.png

PART 2: WiFi Setup

8) Tap the "Go to WiFi Settings" button

8.png

9) Connect to WGL-###### network and come back to Waggle app.

9.png

10) Tap Next button and wait. It may take up to 1 minute.

10.png

11) Choose WiFi network to join.

11.png

12) Enter the password for the WiFi network you chose and tap "Next" button. It may take up to 1 minute.

12.png

13) Tap "Go to WiFi settings" button.

13-1.png

14) Selet your WiFi network.

13-1.png

15) Tap "Yes, connected to ######" button. It may take up to 1 minute.

13.png

16) Enter Waggle name and select printer information.

14.png15.png

17) Wait the Waggle list to load. When the list loads, Tap your Waggle.

16.png

18) Wait to connect to your Waggle. It may take up to 1 minute.

17.png

19) Now Waggle app and Waggle device are successfully connected!

18.png